Machining DataSheet for

General Information:
Material GroupS - Superalloys (Heat resistant and Titanium)
Hardness41.0 HRC
Tensile Strength1290 [N/mm^2]
Machinability Range6% - 19%

Watch the Video:
"How to use the Material Pages"
and get the most out of this page!

Equivalent International Designations for Material F 1537

Standard Name
saeASTM F1537
unsUNS R31537 & R31538

Chemical Composition for Material F 1537

Element Amount
Cobalt (Co)64%
Chromium (Cr)28%
Molybdenum (Mo)6%
Silicon (Si)0.5%
Manganese (Mn)0.5%
Iron (Fe)0.3%
Nickel (Ni)0.2%
Carbon (C)0.1%

Cutting Speeds Recomendations for Heat resistant Ni or Co Based

* Click on the speeds below for higher precision in specific conditions!

ApplicationVc (m/min)Vc (SFM)

Important! The speed estimation is given for an ideal situation:

  • Most suitable carbide grade
  • Stable tool clamping
  • Stable workpiece clamping
  • Good quality raw material
  • A short overhang of the cutting tool.
  • Nominal hardness of the material.
  • etc.
Click on the speeds in the above table to get better precision for specific parameters
Or use our Speed and Feed Calculator

Recommended Carbide Grades for Material F 1537

* If you do nott understand the below table? Read This Explanation to make the most out of it!

Grade for Turning

Grade for Parting Off

Grade for Grooving

Grade for Milling (Indexable)

Recommended Insert Cutting Edge Geometry for Material F 1537

Honing Size:0.02-0.05 mm / 0.001-0.002"
Rake Angle:13° -18°
Land Angle:Neutral
Land Width:0.10-0.20 mm / 0.004-0.008"
Ground Insert:Recommended

Learn more about carbide inserts Cutting-Edge Geometry Parameters.

Enjoy Ads Free Browsing !

Are you tired of ads on our website? Become a premium user for Just 1.5 Dollars per Month and get rid of all the ads pop-ups.

Scroll to Top