General Information:
Material GroupS - Superalloys (Heat resistant and Titanium)
Sub-GroupTitanium alloy
Tensile Strength1020 [N/mm^2]
Machinability Range15% - 30%

Equivalent International Designations for Material Ti-5Al-2.5Fe (Tikrutan)

StandardName


Chemical Composition for Material Ti-5Al-2.5Fe (Tikrutan)

Sorry, Not Availble for this Material


Cutting Speeds Recomendations for Titanium alloys

* Click on the speeds below for higher precision in specific conditions!

ApplicationVc (m/min)Vc (SFM)
Turning60-120200-390
Milling45-90150-300
Parting40-75130-250
Grooving55-105180-340
Drilling55-105180-340

Important! The speed estimation is given for an ideal situation:

  • Most suitable carbide grade
  • Stable tool clamping
  • Stable workpiece clamping
  • Good quality raw material
  • A short overhang of the cutting tool.
  • Nominal hardness of the material.
  • etc.
Click on the speeds in the above table to get better precision for specific parameters
Or use our Speed and Feed Calculator



Recommended Carbide Grades for Material Ti-5Al-2.5Fe (Tikrutan)

* If you don't understand the below table? Read This Explanation to make the most out of it!

Grade for Turning

Grade for Parting Off

Grade for Grooving

Grade for Milling (Indexable)

Recommended Insert Cutting Edge Geometry for Material Ti-5Al-2.5Fe (Tikrutan)

Honing Siz0.02-0.05 mm / 0.001-0.002"
Rake Angl13° -18°
Land AnglNeutral
Land Widt0.10-0.20 mm / 0.004-0.008"
Ground InserRecommended

Learn more about carbide inserts Cutting-Edge Geometry Parameters.

Subscribe to out Newsletter and Get the Free Machinability eBook

No thanks, I’m not interested!

Scroll to Top