- Application Range
- Compatible Grades
- Cutting Speeds
Iscar - IC804 Menu
| General Information: | ||
|---|---|---|
| Brand | Iscar | |
| Grade Status | Old Version | |
| Substrate Class | Very Hard | |
| Coat Type | Thin PVD | |
| Post Treat | N | |
OLD GRADE NOTICE!
IC804 is an older generation grade that is no longer recomended by Iscar
The recomended modern alternative is :IC806
The data below is the data for IC806 However, It should be fairly accurate also for IC804
From Iscar's website:
A tough submicron substrate, TiAlN PVD coated grade followed by a special "SUMO TEC" surface treatment. Suitable for turning Inconel at low to medium cutting speeds.
Application Range for IC806 (IC804)
* If you don't understand the below table? Read This Explanation to make the most out of it!
Equivalent Grades for IC806 (IC804)
The most compatible grade from each brand!
A higher score (Up to 100%) means the grades are more compatible. A lower score or a particular grade not listed does not mean it is not a good grade. It means that its physical and mechanical properties are less close to IC806
Cutting Speed recommendations for IC806 (IC804)
How to use our Cutting Speeds Recommendations
- Pay attention that your desired unit (SFM or m/min) is selected!
- Speeds are given for stable conditions of Machine, Tool, and workpiece.
- An empty cell means the grade is not available for the combination of material and application.
- For more specific Cutting Speeds Recommendations use our advanced
SPEEDS AND FEEDS CALCULATOR
Unit Selector:
SFM
m/min