Machining DataSheet for

General Information:
Material GroupP - Steel
Sub-GroupCarbon Steel
Tensile Strength550-750 [N/mm^2]
Machinability76%

Watch the Video:
"How to use the Material Pages"
and get the most out of this page!

Watch Video

Machining Steel 1035

Steel 1035 is a Carbon Steel material with 0.4% carbon content. Carbon steels range in carbon content between 0.08% to 1%. The machinability is very sensitive to the amount of carbon. Materials with little carbon content (below 0.15%) are too soft and gummy, and materials with a carbon content above 0.5% are harder and thus have lower machinability

Since Steel 1035, has 0.4%, it is relatively easy to machine with a good hardness/mildness balance and a machinability rating of 76%.

You can find here a list of machinability Ratings for different Carbon Steels.

Summery:

  • For general Turning of Steel 1035 at stable conditions use a grade with a Hard substrate and CVD coating.
  • In case you are running at a cutting speed that is lower than 490 SFM (150 m/min), it is better to use a grade with a
    • Hard substrate and PVD coating.
  • For general Milling use a grade with a Semi Hard substrate and PVD coating.
  • For detailed carbide grades recommendations, check the Below Chart, or use the Grades Wizrad.
  • Recommended Cutting speed range for turning at stable conditions is 930 - 1260 [SFM] / 285 - 385 [m/min].
  • Recommended Cutting speed range for milling with stable clamping and short overhang is 570 - 790 [SFM] / 175 - 240 [m/min]
  • For detailed cutting speed recomendations, check the Below Table, or use our Speed and Feed Calculator.

    • Equivalent International Designations for Steel 1035

    Standard Name
    sae1035
    wnr1.0501
    dinC35
    bs060A35
    ss1550
    anforCC35
    uniC35
    unfF.113

    Chemical Composition for Steel 1035

    Element Amount
    Manganese (Mn).60-.90%
    Carbon (C).32-.38%
    Sulfur (S)0.05%
    Phosphorus (P)0.04%

    Cutting Speeds Recomendations for Steel 1035

    * Click on the speeds below for higher precision in specific conditions!

    ApplicationVc (m/min)Vc (SFM)
    Turning285-385930-1260
    Milling175-240570-790
    Parting135-185440-610
    Grooving160-215520-710
    Drilling115-155380-510

    Important! The speed estimation is given for an ideal situation:

    • Most suitable carbide grade
    • Stable tool clamping
    • Stable workpiece clamping
    • Good quality raw material
    • A short overhang of the cutting tool.
    • Nominal hardness of the material.
    • etc.
    Click on the speeds in the above table to get better precision for specific parameters
    Or use our Speed and Feed Calculator


    Recommended Carbide Grades for Steel 1035

    * If you do nott understand the below table? Read This Explanation to make the most out of it!

    Grade for Turning

    Grade for Parting Off

    Grade for Grooving

    Grade for Milling (Indexable)

    Recommended Insert Cutting Edge Geometry for Steel 1035

    Honing Size:0.05-0.08 mm / 0.002-0.003"
    Rake Angle:11° -13°
    Land Angle:Positive
    Land Width:0.20-0.30 mm / 0.008-0.012"

    Learn more about carbide inserts Cutting-Edge Geometry Parameters.

    Start typing and press enter to search

    Scroll to Top