General Information:
Material Group P - Steel
Sub-Group Low Alloy Steel
Tensile Strength [N/mm^2]
Machinability69%

Equivalent International Designations for Steel A333G6

Standard Name
dinP265GH
anforTU42BT

Chemical Composition for Steel A333G6

Element Amount
Manganese (Mn)0.29-1.06%
Chromium (Cr)0.4%
Carbon (C)0.3%
Silicon (Si)0.10 min%
Phosphorus (P)0.025%
Sulfur (S)0.025%

Cutting Speeds Recomendations for Steel A333G6

* Click on the speeds below for higher precision in specific conditions!

ApplicationVc (m/min)Vc (SFM)
Turning255-350840-1150
Milling160-215520-710
Parting125-165410-540
Grooving145-195480-640
Drilling105-140340-460

Important! The speed estimation is given for an ideal situation:

  • Most suitable carbide grade
  • Stable tool clamping
  • Stable workpiece clamping
  • Good quality raw material
  • A short overhang of the cutting tool.
  • Nominal hardness of the material.
  • etc.
Click on the speeds in the above table to get better precision for specific parameters
Or use our Speed and Feed Calculator


Recommended Carbide Grades for Steel A333G6

* If you don't understand the below table? Read This Explanation to make the most out of it!

Grade for Turning

Grade for Parting Off

Grade for Grooving

Grade for Milling (Indexable)

Recommended Insert Cutting Edge Geometry for Steel A333G6

Honing Size:0.05-0.08 mm / 0.002-0.003"
Rake Angle:11° -13°
Land Angle:Positive
Land Width:0.20-0.30 mm / 0.008-0.012"

Learn more about carbide inserts Cutting-Edge Geometry Parameters.

Subscribe to out Newsletter and Get the Free Machinability eBook
Scroll to Top