Machining DataSheet for

General Information:
Material GroupS - Superalloys (Heat resistant and Titanium)
Sub-GroupSuperalloy
Hardness80.0 HRB
Tensile Strength510 [N/mm^2]
Machinability Range15% - 45%

Watch the Video:
"How to use the Material Pages"
and get the most out of this page!


Equivalent International Designations for Material Sanicro 30

Standard Name
dinX2NiCrAlTi3220

Chemical Composition for Material Sanicro 30

Element Amount
Nickel (Ni)34%
Chromium (Cr)22%
Iron (Fe)14.6%
Silicon (Si)0.55%
Manganese (Mn)0.55%
Titanium (Ti)0.5%
Aluminum (Al)0.3%
Carbon (C)0.03%

Cutting Speeds Recomendations for Heat resistant Ni or Co Based

* Click on the speeds below for higher precision in specific conditions!

ApplicationVc (m/min)Vc (SFM)
Turning60-180200-590
Milling45-135150-440
Parting40-115130-380
Grooving55-160180-520
Drilling55-160180-520

Important! The speed estimation is given for an ideal situation:

  • Most suitable carbide grade
  • Stable tool clamping
  • Stable workpiece clamping
  • Good quality raw material
  • A short overhang of the cutting tool.
  • Nominal hardness of the material.
  • etc.
Click on the speeds in the above table to get better precision for specific parameters
Or use our Speed and Feed Calculator


Recommended Carbide Grades for Material Sanicro 30

* If you do nott understand the below table? Read This Explanation to make the most out of it!

Grade for Turning

Grade for Parting Off

Grade for Grooving

Grade for Milling (Indexable)

Recommended Insert Cutting Edge Geometry for Material Sanicro 30

Honing Size:0.02-0.05 mm / 0.001-0.002"
Rake Angle:13° -18°
Land Angle:Neutral
Land Width:0.10-0.20 mm / 0.004-0.008"
Ground Insert:Recommended

Learn more about carbide inserts Cutting-Edge Geometry Parameters.

Enjoy Ads Free Browsing !

Are you tired of ads on our website? Become a premium user for Just 1.5 Dollars per Month and get rid of all the ads pop-ups.

Scroll to Top