Machining DataSheet for

General Information:
Material GroupM - Stainless Steel
Sub-GroupFerritic Stainless Steel
Hardness75.0 HRB
Tensile Strength450 [N/mm^2]
Machinability Range35% - 90%

Watch the Video:
"How to use the Material Pages"
and get the most out of this page!

Equivalent International Designations for Stainless Steel 410S

Standard Name
unsUNS S41008

Chemical Composition for Stainless Steel 410S

Element Amount
Iron (Fe)87%
Chromium (Cr)12%
Silicon (Si)1.00%
Manganese (Mn)1.00%
Nickel (Ni)0.6%
Carbon (C)0.08%
Phosphorus (P)0.04%
Sulfur (S)0.03%

Cutting Speeds Recomendations for Stainless steel - Ferritic

* Click on the speeds below for higher precision in specific conditions!

ApplicationVc (m/min)Vc (SFM)

Important! The speed estimation is given for an ideal situation:

  • Most suitable carbide grade
  • Stable tool clamping
  • Stable workpiece clamping
  • Good quality raw material
  • A short overhang of the cutting tool.
  • Nominal hardness of the material.
  • etc.
Click on the speeds in the above table to get better precision for specific parameters
Or use our Speed and Feed Calculator

Recommended Carbide Grades for Stainless Steel 410S

* If you do nott understand the below table? Read This Explanation to make the most out of it!

Grade for Turning

Grade for Milling (Indexable)

Grade for Parting Off