General Information:
Material GroupP - Steel
Sub-GroupLow Alloy Steel
Tensile Strength490-640 [N/mm^2]
Machinability Range70% - 84%

Equivalent International Designations for Steel A350LF5

StandardName
saeASTMA350LF5
wnr1.5622
din14Ni6
anfor16N6
uni14Ni6
unf15Ni6


Chemical Composition for Steel A350LF5

Sorry, Not Availble for this Material


Cutting Speeds Recomendations for Low Alloyed Steel (Alloying elements less then 8%)

* Click on the speeds below for higher precision in specific conditions!

ApplicationVc (m/min)Vc (SFM)
Turning305-3701000-1210
Milling190-230620-750
Parting145-175480-570
Grooving170-205560-670
Drilling125-145410-480

Important! The speed estimation is given for an ideal situation:

  • Most suitable carbide grade
  • Stable tool clamping
  • Stable workpiece clamping
  • Good quality raw material
  • A short overhang of the cutting tool.
  • Nominal hardness of the material.
  • etc.
Click on the speeds in the above table to get better precision for specific parameters
Or use our Speed and Feed Calculator



Recommended Carbide Grades for Steel A350LF5

* If you don't understand the below table? Read This Explanation to make the most out of it!

Grade for Turning

Grade for Parting Off

Grade for Grooving

Grade for Milling (Indexable)

Recommended Insert Cutting Edge Geometry for Steel A350LF5

Honing Siz0.05-0.08 mm / 0.002-0.003"
Rake Angl11° -13°
Land AnglPositive
Land Widt0.20-0.30 mm / 0.008-0.012"

Learn more about carbide inserts Cutting-Edge Geometry Parameters.

Subscribe to out Newsletter and Get the Free Machinability eBook
Scroll to Top